AUTONET TV

Water Everywhere (Clogged Drains)

It's bad enough when you mistakenly leave a window open in your vehicle on a rainy day and you find your carpet soaked.  But what in the world is going on when your windows are closed tight, not leaking and you STILL wind up with wet carpet? The answer could be something you might not even know your vehicle has.

And the answer is? Drains. And those drains can get clogged.  Yes, your vehicle has several drains with tubes or hoses attached to them that you really never see.  There are some in and around the hood that channel rainwater down to the ground.  There are some that take condensation from the air conditioner and allow it to flow outside.  And if your vehicle has a retractable sunroof or moon roof, there are small drains at each corner that connect to tubes that go through the vehicle body down to an exit near the ground. 

Considering all the leaves, dirt, dust and other debris your vehicle encounters on a daily basis, it's not surprising that these drains can get blocked.  Then when it rains, that water winds up going to the place of least resistance.  Sometimes, that's inside the cabin where it shows up as wet carpeting.

So, what's the solution?  You may be tempted to see if you can clean out those drains yourself.  But there are many people who have tried blowing condensed air in the drains only to find that they literally blow the tubes off of their connections inside the vehicle's body.  Reattaching those can be a time-consuming, labor-intensive, expensive proposition.

A trained technician has the equipment and knowledge to clear out those drains properly. To prevent clogged drains, regular maintenance is the key, so when your vehicle is in for other periodic maintenance like oil changes and tire rotations, the technician can make sure all drains are clear and flowing like they should.

Ken's Auto Center
9555 Black Mountain Road
San Diego, CA 92126
8585788200

No Yolk! Rotten Egg Smell (Sulfur Smell Causes)

The pungent smell of rotten eggs can send people running for the hills.  So when that odor is inside your vehicle, yikes!  Yolks!  The good news is that a trained service technician can search the source of that smell and stanch the stench… that comes from another words that begins with S.  Sulfur.

Fuel contains small amounts of hydrogen sulfide, but they're enough to stink up a vehicle when it's not properly burned.  You may know that the smell of rotten eggs can often be a sign of a catalytic converter that isn't working the way it should.  That could be due to age, damage or an abundance of oil that's clogging it up. 

If a sensor in charge of managing the fuel has failed, the engine can run with too rich of a fuel mixture.  That can overload the catalytic converter and allow some of the byproducts to escape without interruption from the chemical reaction that is supposed to prevent them from going out the tailpipe.

There's another possibility, but it's usually only in stick shift vehicles.  That's leaking, old transmission fluid.

Catalytic converter repairs are best left to a professional. Technicians at your vehicle service facility have equipment and training that can help them pinpoint the cause of this funky fragrance.  Once the cause is found, repairs made and/or parts replaced, the smell should go away fairly rapidly.

Ken's Auto Center
9555 Black Mountain Road
San Diego, CA 92126
8585788200

Some New Boots (Suspension Maintenance)

There are some boots that don't come in a shoe box and aren't worn on your feet.  They are called axle or CV boots, and they can be important parts for many vehicles.

That CV stands for constant velocity.  CV axles are mainly used in front-wheel drive and all-wheel drive vehicles. They're also used in some rear-wheel drive vehicles with independent suspensions.  They have two CV joints, one inner and one outer, placed between the axle and the drive wheels.  That way the vehicle's engine power can drive the wheels, no matter what angle they are.  They also adjust for the different speeds wheels turn as they go around corners. 

Because roads are full of all sorts of hazards (dirt, oil, water, grime), these CV joints need to be protected.  They also have grease in them to keep the bearings moving smoothly.  That's the job of the rubber boots that are supposed to keep that debris out.  These CV or axle boots are made of rubber or plastic and usually last a long time without any problem.  But sometimes they fail, either from being hit by debris or age causing the rubber or plastic to deteriorate.  That can allow the grease to leak out of the joint and the moisture to get in.  And that's where the trouble is.

So it's important to have a vehicle's CV boots checked periodically, especially when they begin to have more than 100,000 miles/160,000 kilometers on them.  A technician inspects them for tears or cracks.  Sometimes if the problems are found early enough, the boots can be replaced and the joints can be re-packed with grease. 

But sometimes the CV joint can wear out even though the boot is intact.  When the CV joint fails, you might hear a grinding, humming or clicking noise and feel vibration.

Some of these can be difficult to access for service, so many service advisors will recommend replacing the joints and boots at the same time.  Just remember, new CV boots won't make a fashion statement, but they will keep your vehicle going down the road for years to come.

Ken's Auto Center
9555 Black Mountain Road
San Diego, CA 92126
8585788200

Lean Times (Shocks and Springs)

You may have noticed your vehicle going through lean times.  By that, we mean it's literally leaning to one side.  When you notice that, you should get it checked out at your service facility soon because you could have a serious problem.

Many things can cause a vehicle to lean.  You may have problems with your struts, shocks or springs.  They all work in tandem to make your ride more comfortable.  The struts bear the weight of the vehicle's body, the shock absorbers employ a piston that keeps your tires in contact with the road and controls movement of the vehicle's body.  Springs also absorb impacts from uneven road surfaces.

If these components get stuck, either too high or too low, they cause your vehicle to lean.  That's because that side of the vehicle isn't at the height it is designed to be.  A technician will determine where the problem is.  Outside elements such as moisture plus hard knocks to these components can weaken them, eventually resulting in a failure.  The metal can get so fatigued that it breaks.  Often when one side of a vehicle is too high or too low, your service advisor will advise you to have the other side done as well.  That's because if only one side has new parts installed, it won't be level with the side that has old parts. 

There are a couple of other reasons vehicles can lean.  One is that the suspension can be bent or the chassis twisted, again due to wear and tear by driving on rough roads, over badly maintained railroad tracks or in deep potholes. 

Another reason your vehicle may lean is that the tires and/or wheels aren't all the same size.  Or one side might have drastically over or underinflated tires.  This can be a dangerous condition since the imbalance can affect steering and handling.

Considering what drivers put suspension parts, tires and wheels through, it's not surprising that they can be punished so much that they don't hold up like we want them to.  A level-headed driver will make sure to be driving a level vehicle by making sure these components are maintained in good condition.

Ken's Auto Center
9555 Black Mountain Road
San Diego, CA 92126
8585788200